Factory sale cement grout injection mixer and agitator for railway

Factory sale cement grout injection mixer and agitator for railway are primarily driven by electric motors. The pulp is sucked in from below in the form of a vortex and expelled from the top of the barrel to create a fast flow of liquid, forming a strong vortex in the barrel. This will give you dry powder and water. Stir thoroughly to prepare a slurry with a low water to binder ratio. Compared to common mixers on the market, factory sale cement grout injection mixer and agitator have the characteristics of faster pulping and more uniform mixing of pulp. It is one of the main equipment of a large pulping station.

Factory sale cement grout injection mixer and agitator for railway are primarily used for mixing and preparing grout and other similar slurries that require strong premixing. Factory sale cement grout injection mixer and agitator for railway used for pressure grout construction such as railroad and highway construction, mining, hydropower engineering, insulation and waterproofing, grout of building foundations.

Advantages of factory sale cement grout injection mixer and agitator for railway:

1. Highly efficient and large reserves suitable for various grout injection engineering operations.

2. Safe and reliable; the main component motor has a high level of protection.

3. The mixing arm of the storage tank adopts a pre-modified frame structure with high strength, high force, no deformation.

4. High speed centrifugal mixing, uniform mixing, no precipitation.

5. High reliability, motor installed vertically, convenient sealing, high sealing effect, low failure rate. Even if there is little slurry leakage from the stirring shaft of the motor, it will not affect production or use in a short period of time. period.

Precautions regarding the use of factory sale cement grout injection mixer and agitator for railway:

1. Check if the rotation of the stirring impeller is correct and make sure that the slurry pipe does not leak.

2. Add an appropriate amount of water, turn on the power of the device to clean and moisten the tapping barrel and pipe, and drain the water to the tapping machine after cleaning.

3. Add a certain amount of water to the machine. (Before starting the machine, close the main valve on the front of the hopper to stop adding water to the hopper, but since the main water supply cannot be turned off, it can be lowered properly. The transmission device can be cooled and cleaned. The unit burns during the pulping process, otherwise the drive components burn.) Open the pulping machine and follow the rules. Add the powder evenly in sequence, control the feeding time, add all the powder, then continue stirring for 3-5 minutes. ;

4. Transport the prepared slurry to the slurry storage tank to maintain dynamic slurry storage.

5. Immediately after pulping is complete, clean the equipment and pipeline, open the pulping machine and circulate the remaining cement slurry to the pulping machine and pipeline.

If you are interested in factory sale cement grout injection mixer and agitator for railway, please contact us